FR E520 3.7K PDF

FR-EK to K(C). FR-EK to K(C) ○Removal. (For the FR- EK to K, FR-ESK to K, FR-EW-. K to K). FR-E FR-EKND to KND. INSTRUCTION MANUAL. OUTLINE Economy, Trade and Industry) in September, applies to the K and less. : USED MITSUBISHI FR-EK-NA,FR-PA INVERTER, 5hp, v,BOXYB: Everything Else.

Author: Fenrijora Doukinos
Country: Japan
Language: English (Spanish)
Genre: Education
Published (Last): 25 September 2014
Pages: 197
PDF File Size: 14.44 Mb
ePub File Size: 8.97 Mb
ISBN: 498-4-82502-295-4
Downloads: 81685
Price: Free* [*Free Regsitration Required]
Uploader: Gulabar

Alarm stop display “E. Check that the input signal lines are not affected by external noise. 3.7k optional brake resistor cannot be used with 0. Check point Check the motor for use under overload.

To change the Pr.


The cooling fan is connected to the cooling fan connector beside the .37k circuit terminal block of the inverter. Those of the V class are isolated. The charging area and control printed board are exposed on the rear surface of the operation panel. Page Page – Output terminal function selection Pr. Frequency Setting Command Selection pr. Set “0” in Pr.


The following list indicates purpose of use and corresponding parameters. Using the connection cable for operation 1 Remove the operation panel.

FR-EK-NA | Mitsubishi | EU Automation

Automatic restart after instantaneous power failure uses a reduced-voltage starting system in which the output voltage is raised gradually with the preset frequency unchanged, independently of the coasting speed of the motor.

Enquire now Just send us your name, company, telephone number and email to receive a price as soon as possible Name. Always read this chapter before using the equipment.

Press the key, to choose the MODE parameter setting mode. This manual also for: If your fault does not correspond to any of the following errors or if you have any other problem, please contact your sales representative. Single-phase V power input! Parameter Write Disable Selection pr. Chapter 6 Chapter A member of our team will respond as soon as possible.

Terminal FM provides the pulse output. Meter frequency Meter Calibration pr. When “Operation not continued for OL signal output” is selected using Pr.


Cooling Fan Operation Selection pr.


Page – Zero current detection Pr. Refer to page 48 for selection. Check that the e250 parameter settings are correct Pr. OLT” alarm code stopped by stall prevention is displayed and operation stopped.

For details, refer to the instruction manual of the power regeneration common converter FR-CV. There is no cooling fan in the FR- E Output frequency Parameter Factory Setting Just send us your name, company, telephone number and email to receive a price as soon as possible.

When removing the operation panel, always fit the rear cover e20 FR- E5P. The priorities of external terminal of the frequency command are in order of jog, multi-speed, terminal 4 and terminal 2. They’ve always been helpful and efficient when I have placed orders with them.